 |
| DAI-EL Latex takes advantages of superior DAI-EL characteristics such as resistance to heat, chemicals, oils and weather. DAI-EL latex provides effective protection for metal and surface improvement for textile binders and ordinary rubber. It can be applied by impregnation and spray-coating techniques. |
NOTE
 Since the product quality may be affected by the application method, the latex should be used as soon as possible even within the pot life.
Fluid A and Fluid B's shelf life three months.
Clear varieties and colors other than those shown are also available, upon request. |
NOTE:
*1 Liquid specific gravity measured by weight in a 100 cc measuring cylinder (with fluid A and fluid B mixed together)
*2 Measured using a type B rotating viscometer (")
*3 Measured using a #4 Ford cup.
*4 Life at 25 after fluid A and fluid B have been mixed at standard ratio.
In the separated states fluid A and fluid B each has pot life of 3 months.
Because the product quality may be affected by the application method, the latex should be used as soon as possible even within the pot life.
When using a spray application method, dilute with solvent until the solid content is less than 10% by weight.
Values shown are those obtained during testing and should not be taken as absolute. |
Chemical resistance (GL-152)
(70h at room temperature) |
 |
Mechanical properties of film
(fluid A and fluid B mixed) |
* IRHD (International Rubber Hardness Degrees)
Measured for 30 seconds using a Wallace microhardness tester |
| Properties of GLS-213 and DPS-231 films |
* This is a typical DAI-EL fluoroelastomer product from Daikin Industries, which was molded in standard condition. |
 Features
- Film coating provides same resistance to heat, chemicals, oils and weather.
Grades are available for self lubrication and non-adhesive application.
Application example |
|
|
